Eight Easy Ways in Replacing an Exhaust Catalytic Converter
To replace your old exhaust catalytic converter with a brand new one, you first need to jack up your vehicle and then take away the bolts and clamps. Then, remove the old catalytic converter and purchase a brand new one. Once you've the replacement part, attach this one to the automobile, and then attach the bolts. You then should check out leaks, and lastly, lower the car to the ground.
One of the most expensive components of a vehicle to repair is the exhaust catalytic converter. This is the reason why numerous car owners often opt to repair a malfunctioning catalytic converter on their own. Obviously, you should know what you are doing so you will not end up doing more harm to your car. Here you'll know the simple steps in replacing an exhaust catalytic converter.
Raise your car
Get 4 jacks and utilize 2 to raise your automobile on the front part and the other two on the back area. Be sure that you are placing the jacks on the jack points of the automobile. And once the car is raised, use jack stands to keep its position in place.
Take out the bolts and clamps
The next step that you should do is take out the bolts and clamps that are holding the catalytic converter in place. These things may be difficult to remove because of their size as well as the awkward way they're placed. To help in their removal, use lubricant around them and use an adjustable wrench to loosen and take off them. However, if you find that you cannot remove the bolts and clamps, you may just have to drill or saw them apart. Being mindful of this, you also must have their replacement with you. After you have taken off all the bolts, lose the heat shield from its place and then the clamps.
Remove the old catalytic converter
Take away the catalytic converter from the car but expect that this will also be a little challenging. Try to shake it to loosen it from the pipes which are connected to it. You may also tap it a bit utilizing a rubber mallet to remove it from its placement.
Buy a new catalytic converter
Visit the nearest store which sells replacement catalytic converters and find out if the part that's specific for your vehicle is available. You can also buy a generic part; nonetheless, this would typically demand welding work to attach it to your automobile. Specific parts, however, are simpler to set up because they're already pre-welded to the right pipes.
Affix the brand new catalytic converter
Install the brand new catalytic converter by affixing it to the exhaust pipe that comes from the front area of the car. Then, firmly fasten it to the pipes by tapping it with the rubber mallet.
Connect the bolts
Once the new catalytic converter is attached to the car, you may now secure this in place. If you have taken a heat plate off earlier, replace this. And then, attach the bolts and be sure to tighten them for protection.
Search for leaks from the brand new catalytic converter
You now need to see if the brand new catalytic converter will create leaks. Slide out from under the vehicle and turn the engine on. Check the place where the catalytic converter meets with the exhaust pipes, for this is where most leaks take place. If you find a leak, you can patch this up using an automotive exhaust patch kit. You need to then check the location again for leaks once the patch has set based on its producer’s suggestions.
Lower your vehicle down
One at a time, eliminate the jacks from below the automobile so the automobile can now be lowered down.
Some states need you to report a replacement of the catalytic converter during a car inspection. Thus, it is important that you document the replacement of this vehicle part.
Locate replacement catalytic converters at http://www.marcomuffler.com/services.html