Ways to set up a driveway gate include getting ready all the supplies, determining the location of the gate, digging the post holes, setting the posts, developing the hinge hardware holes, installing the gate hinges and gate, and testing your gate.
Gates offer a variety of functions to a house, especially when coupled with a fence. They serve as an accessory to a property, and they also keep surprise guests from quickly entering your property. Furthermore, gates make you feel assured that your children and pets are secure within your property. Setting up a driveway gate is not difficult to do. Listed below are the guidelines to do it.
Get ready all the materials
The very first thing you should do is to prepare all the materials you will need. These supplies include a posthole digger, a level, plumb line, scoop, fast-setting concrete, screwdriver or electronic drill, wrench, gate, as well as gate hardware, like latch assembly, screws and hinges.
Determine the area of the gate
The next thing you should do is to determine the exact area of your gate. Although your gate can go as far as the edge of your lot, you should determine the size of your gate to make sure that every automobile you possess can pass through it easily and securely.
Excavate the post holes
After you have determined the place and dimension of your gate, excavate the holes where the posts of the gate will stand. This means you'll have to dig 1 hole on one side of the driveway and another one on the reverse side, just opposite the first hole. These openings will hold the posts of your gate, so your gate will stay upright. Make sure to dig at least 2 to 3 feet into the ground, just so it would be deep enough to carry the posts and their weight in place.
Set the posts
After you got your holes, position the posts in them individually. Put one post inside one opening and then ensure that it's leveled properly by utilizing the plumb line and level. As soon as you've ensured that the post is flattened, pour the fast-setting cement into the hole. You'll need to hold the post while the cement is being poured just to ensure that the post will remain in place. Once you are finished with the very first post, do the same thing to the other post, and let the concrete set until the following day.
Create the hinge hardware holes
When the concrete has set, you'll now need to produce the holes where the joint hardware will be put. Identify the hardware's area on the post, and then use an electronic drill to make holes. If you were unable to build your posts completely level, just be sure that your Los Angeles driveway gates would have enough clearance once you close and open them.
Mount the gate hinges and gate
As soon as the holes are built on the posts, mount the hinges unto the posts and hang the gates on the hinges. Make sure you tighten the screws of the hinges very well, so that your gates will remain safely in place. After that, get the latch assembly and attach it on the gates at the correct location.
Test out your gate
Once you have set up the gate, check if it opens and closes correctly and if the latch locks correctly. Make sure that your gate can open wide enough and close completely, and it should also have the right amount of floor clearance for the land surface.
If you need an electric driveway gate, connect the gate-opener brackets and also the electric accessories. Then, position the access pad, so that it will be convenient to use while you're inside the car.
Find out more about Los Angeles driveway gates at http://www.nobleforge.com/