The methods for setting up a shower pan start with the location of framing square, then preparation of the drain, installation of the shower drain pipe, installation of the shower drain fitting, ranking up of the shower pan, preparing and also apply the bedding materials, setting of the shower pan in position, and finally application of the finishing details.
Shower pans are considered the portion of a bathroom shower stall which you stand on while showering. The pan keeps the home from being damaged by water, while at the same time supporting the user’s bodyweight. Several homeowners work with bathroom remodeling contractors to install their shower pans; nonetheless, you can do the task on you own. Read this article to guide you through the task.
Positioning of framing square
Have a framing square positioned over the corners where the wall studs match the floor in the area where you intend to set up the shower pan. Utilize the square to make sure that the place where the 2 stud wall surfaces meet is a square. There may be 1 or 2 corners at the meeting point of the 2 stud walls, with respect to the shower pan’s design and style. If there's any part of the stud that doesn't seem right, correct this before moving on with the other jobs.
Make the drain
With the aid of a jigsaw, cut a five inch by five inch square within the subfloor where the shower drain would be headed. See the manufacturer’s instructions on the shower pan and refer to them about the dimensions required for the drain’s location.
Set up shower drain pipe
Set up the pipe for the shower drain based on the maker’s guidelines that came with the item. Have the shower pan’s guidelines and refer to this regarding the length of the drain pipe that should adhere above the floor’s surface through the hole which was made in the subfloor.
Build shower drain fitting
Set up the fitting of the shower drain on the lower area of the shower pan and on its opening by following the company’s guidelines on the drain. Have the shower pan positioned on the ground in a manner that the drain fitting situated on the pan’s bottom will slide over the drain water pipe inside the floor. As required, slide the pan to be sure that the pan’s sides are pressed up towards the wall studs.
Level the shower pan
Have a 4-foot level placed in many directions inside the pan. Bring the percolate of the level between the 2 markings by putting wood shims underneath the shower pan. With the use of a pencil, create a mark over the shower pan’s set up flange. Lift the shower pan up and have it positioned inside. Then, eliminate the shims.
Make and also apply bedding materials
Prepare the bedding material which the company advises, that's often mortar or plaster, by combining it according to the directions located in the bag. Pour the bedding material to the floor where you will have the shower pan entirely positioned and spread it by using a trowel. Make sure that you have an adequate amount of bedding materials to back up the shower pan’s whole underside.
Set shower pan in place
Before the bedding materials sets, get the shower pan put over it. Be sure that the drain fitting on the underside of the pan would slide in the drain pipe which will emerge right through the ground. Press down on the shower pan in a level way until you realize that the installation flange gets to the markings on the studs that you created earlier. Ensure that the pan’s front side edge is reaching the subflooring.
Apply finishing touches
Allow the bedding materials set. Put cement board or drywall on the wall studs and over the pan’s installation flange. Leave a 1/8-inch space between the cement board or drywall and also the shower pan’s splash rim.
Since this job and also the items important to it cost money, it is essential that you plan the task well. Do thorough research, and do not attempt the project until you feel that you are totally ready.
If you need to locate bathroom remodeling contractors, take a look at http://www.alcoaconstruction.com/renovations/bath-remodeling/